In a nutshell: Picking a chassis is likely one of the most important steps when constructing a PC. It defines the system’s general profile and units limits on inner elements. If you can entry a 3D printer, this DIY ITX case, with its distinct early 2000s retro look, is a sweet-looking possibility.
Modder WhoIsLudwig just lately launched a blueprint and information for a singular 3D-printed ITX PC case. The chassis can home respectable gaming PC elements with first rate cooling.
Dubbed the Kubic, this PC casing combines features of sure early 2000s retro units for a singular however nostalgic look. The modder claimed inspiration from the distinctive workstations launched by NeXT within the late 80s and early 90s. The prime deal with recollects two distinct cube-like units from the 00s – Apple’s Power Mac G4 Cube and the Nintendo RecreationCube.
The chassis is designed for ITX profiles to make it accessible to these with smaller 3D printers. He examined it on a Bambu A1 Mini, and it is printable on any mannequin with at the least 180 x 180 mm of mattress clearance.
On prime of the ITX motherboard, the chassis can match a CPU warmth block and fan with a top of up to 100 mm. It helps any two-slot graphics card with a size of up to 220 mm, primarily together with mainstream fashions just like the GeForce RTX 4060, Radeon RX 7600, or their direct predecessors. Builders can add up to 4 2.5-inch drives.
The Kubic is proscribed to SFX energy provides. Modifying the design for an ATX PSU is not not possible, but it surely might introduce thermal compromises.
Chassis followers up to 140 mm and 30 mm thick are supported and are presumably non-compulsory for builders counting on built-in graphics slightly than distinct GPUs. However, the modder claims a single fan can stabilize a CPU at up to 94 levels Celsius and a GPU at up to 75 levels within the worst-case situation. With an AMD Wraith Spire cooler and an Arctic P14 PWM PST fan, the modder’s AMD Ryzen 5 3600 and RX 6600 by no means exceeded 75 levels. The warmth consumption is on the underside, with the exhaust on the highest.
WhoIsLudwig posted detailed meeting directions at Autodesk Instructables and the required 3D printing file on Printables. He used PLA filament for the mission. Screws and a soldering iron are required.
